Mangal And Barbecue Calls

The design of both types of extraction has common elements. It's an umbrella or a dome, and a pipe it connects. The dome is designed to collect the smoke, and the tube takes it to the top. The extraction has a good aerodynamic, because the smoke is very active.

It's important! The gear only works if the fire is well burned. At a stage when the fire just burns, the smoke has almost the same density as the air, because the extraction is useless.

How to make a metal smoker with his hands.

Example of extraction from metal

Metal extraction may have a round, oval, square or rectangular section. But the last two types of metal extraction by their own hands are the most simple, since the manufacture of a dome umbrella will require certain skills and a lot of time.

It is desirable that the size of the opacimeter slightly exceeds the parameters Barbecue or Mangal♪ Then his aerodynamic properties will be optimistic for rapid smoke removal. In this case, we shall consider a design of about 1, 5 metres in diameter. The sheet steel may be taken as a material for its manufacture by a thickness of 1, 5 to 2 mm. This is the most economical option. But if you need a longer and more beautiful design, you can take copper leaflets.

The tools will require:

• Bulgarian;
• hammer;
• Blind instruments;
• Welding machine.

Metal extracts for mangalls require some skills in blade and welding.

We need to take care of the means of fixing the manhal. It could be metal or bricks on which the smoke collector holds. In some cases, he is hung up on chains to the ceiling of the conversation.

The brick's better to take the hot one, so the design will take as long as possible. The cement solution will serve as a stacking material. The proportions of the substitution shall correspond to the cement mark. I mean, if the Cement of Mark 4, its ratio to sand should be 1X4. It's possible to use a glynnium-pose solution, but it won't be so strong.

In addition, four metal coal cuts would be required. Their length shall be equal to the width of the walls of the mangal. I mean, if the barbecue has 1X1, 5 meters, 2 subways, and two, one and a half meters. They should serve to support the extraction. To this end, corners shall be placed on the walls of the angla, and only on top of them shall the extraction be started.